Arid
三维非均质模型上聚合物及有机交联聚合提高采收率研究
其他题名A Study of Oil Recovery Enhanced by Polymer and Phenolic Resin-Crosslinked Polymer on Heterogeneous Sand Packs
李振泉; 祝仰文; 刘坤; 张以根; 宋新旺; 尹德江
来源期刊油田化学
ISSN1000-4092
出版年2002
卷号19期号:1页码:73-76,67
中文摘要所用三维非均质物理模型高100mm,平面边长500mm,平面上一条对角线两端设注入井和产出井,沿对角线有渗透率约3.0mum~2的高渗条带,两侧为0.5mum~2的低渗区。在平面内均匀布置7排7列共49个测压点。驱替液有地层水;1500mg/L聚合物溶液(0.3PV);1500mg/L聚合物+1200mg/L酚醛树脂交联凝胶(0.2PV)。驱替温度70 ℃。水驱、聚合物驱、交联聚合物的采出程依次增大;聚合物驱、交联聚合物驱含水曲线上出现两个低谷区,曲线振荡明显,交联聚合物驱含水曲线振荡尤其剧烈。通过紧靠注入和产出井的1点和49点,主流线中间点25点和非主流线上38点,水驱死油区内36点和45点处压力变化曲线的对比,及聚合物和交联聚合物驱替液G’和G"曲线的对比,认为交联聚合物驱采收率高于聚合物驱采收率的原因,是具有更高弹性的交联聚合物驱替液改善油藏非均质性、扩大波及体积、提高后续注水冲刷效能、改善驱替效果的能力均更强。
英文摘要The hetergeneous sand packs used in the oil displacement experiments are of 50 X 50 X 10 era3 in volume and constructed with an injection and a’production wells at the corners connecting a diagonal, along which a high permeable zone of ca 3. 0 |um2 lies and other areas are low permeable (ca 0.5>m2). In the quadratic plane 49 pressure measuring points are arranged in 7 X 7 arrays. The flooding fluids used are: formation water; 1 500 mg/L polymer solution (0.3 PV); 1 500 mg/L polymer + 1 200 mg/L phenolic resin crosslinked gelled solution (0.2 PV). Flooding temperature 70°C . The oil recovery by water flood (WF), polymer flood (PF) and crosslinked gelled solution flood ,(CPF) increases in order WF< PF< CPF. Two minima are observed on water cut-volume injected or -time curves for PF and CPF and the curves oscilate dramatically and particularly for CPF. The comparison of pressure curves at points 1 and 49 (near the injection and production wells), 25 ( in the medium of main stream) and 38 (outside the main stream), and 36 and 45 (in the blind zones for WF) and of G’ and G" curves for polymer and crosslinked polymer flooding solutions shows that higher enhancement in oil recovery by CPF than that by PF can be explained by higher ability of crosslinked gelled polymer .solution with higher elasticity to improve reservoir heterogeneity, to enlarge sweeping volume, to intensify the flush efficiency of .successive injection water arid to increase oil displacing efficiency.
中文关键词聚合物溶液 ; 交联聚合物溶液(凝胶) ; 驱油效率 ; 驱油机理 ; 非均质模型 ; 提高原油采收率 ; 含水率曲线
英文关键词polymer solution crosslinked (gelled) polymer solution oil displacing efficiency oil displacing mechanisms heterogeneous physical models enhanced oil recovery (EOR) water cut curves
语种中文
国家中国
收录类别CSCD
WOS类目ENERGY FUELS
WOS研究方向Energy & Fuels
CSCD记录号CSCD:1273978
资源类型期刊论文
条目标识符http://119.78.100.177/qdio/handle/2XILL650/203569
作者单位中石化胜利石油管理局地质科学研究院, 东营, 山东 257015, 中国
推荐引用方式
GB/T 7714
李振泉,祝仰文,刘坤,等. 三维非均质模型上聚合物及有机交联聚合提高采收率研究[J],2002,19(1):73-76,67.
APA 李振泉,祝仰文,刘坤,张以根,宋新旺,&尹德江.(2002).三维非均质模型上聚合物及有机交联聚合提高采收率研究.油田化学,19(1),73-76,67.
MLA 李振泉,et al."三维非均质模型上聚合物及有机交联聚合提高采收率研究".油田化学 19.1(2002):73-76,67.
条目包含的文件
条目无相关文件。
个性服务
推荐该条目
保存到收藏夹
导出为Endnote文件
谷歌学术
谷歌学术中相似的文章
[李振泉]的文章
[祝仰文]的文章
[刘坤]的文章
百度学术
百度学术中相似的文章
[李振泉]的文章
[祝仰文]的文章
[刘坤]的文章
必应学术
必应学术中相似的文章
[李振泉]的文章
[祝仰文]的文章
[刘坤]的文章
相关权益政策
暂无数据
收藏/分享

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。