干旱区生态环境知识资源中心

Satellite-based thermal infrared remote sensing has greatly contributed to the development and improvement of remote sensing-based evapotranspiration (RS-ET) mapping algorithms. Radiometric temperature (T-s) derived from thermal sensors is inherently different from the aerodynamic temperature (T-o) required for solving the bulk formulation of sensible heat (H). The scalar roughness length (z(oh)) representing heat transport mechanism and described by the dimensionless parameter kB(-1) was used to account for the discrepancy between T-s and T-o. Surface Energy Balance Algorithm for Land (SEBAL), with its indigenous approach of linearly relating dT (near-surface temperature gradient) with T-s across the imagery, maintained that this approach would absorb the impacts of differences between T-s and T-o. Therefore, it utilized a constant kB(-1) value of 2.3 in its initial version, and later switched to a constant z(oh) (z(1)) value of 0.1. In this study, we investigated the influence of these changes in SEBAL by testing four different approaches: (i) z(oh) derived from a constant kB(-1) of 2.3, (ii) constant z(oh) (z(1)) = 0.1 m, (iii) constant z(oh) (z(1)) = 0.01 m, and (iv) spatially variable z(oh) from kB(-1) parameterization. SEBAL was applied on 10 high-resolution airborne images acquired during BEAREX07-08 (Bushland Evapotranspiration and Agricultural Remote Sensing Experiment) and validated against measurements from four large weighing lysimeters installed on two irrigated and two dryland fields. The spatially variable kB(-1) produced statistically different and improved ET estimates compared to that with constant kB(-1) and constant z(1) (z(oh)) approaches. SEBAL performance for irrigated fields representing high ET and complete ground cover surfaces was markedly different from that for dryland fields representing greater soil water deficits with sparser vegetation cover. A variable kB(-1) value derived from a physical model generated good overall estimates while delivering improved performance for dryland agricultural systems. Overall, this study focused on the classical problem of estimating heat transfer from two contrasting hydrological regimes i.e. irrigated and dryland agriculture and illustrated the existing need for a realistic consideration of excess resistance to heat transfer in single-source resistance modeling frameworks. (C) 2013 Elsevier B.V. All rights reserved.