干旱区生态环境知识资源中心

Capillary barriers (CBs) represent useful, low-cost systems for limiting water infiltration and controlling seepage at solid waste landfills in semiarid and arid regions. The application of CBs in wet regions can be problematic due to loss of water-impermeable properties under high-frequency precipitation. A potential solution is to alter soil grain surfaces to become water repellent by mixing or coating the soil cover material with hydrophobic agents (HAs). In this study, hydrophobic CBs comprised of sands mixed with environmentally friendly HAs (oleic acid [OA] and stearic acid [SA]) were studied. Water repellency (WR) characteristics for hydrophobized sand samples with different HA contents and representing different coating methods (mixing in and solvent aided) were measured. Initial contact angles (alpha(i)) for OA-coated samples sharply increased with increasing HA content and reached peak values of 97 to 101 degrees at 0.75 to 1.0 g HA kg(-1) sand, whereafter alpha(i) gradually decreased. Measured alpha(i) values for SA-coated samples increased sharply to 90 degrees and then gradually reached a maximum of 108 degrees at 6.0 g kg(-1) HA content. Each test sample exhibited a decrease in contact angle (alpha) withtime (t) and reached an apparent equilibrium after around 1200 s. The time dependence of alpha was expressed by an exponential function, alpha = alpha(i) exp (-At), where A is the coefficient of temporal change in WR (s(-1)). While the A values for the solvent-aided OA-coated samples were relatively constant (between 3 x 10(-4) and 6 x 10(-4) s(-1)), A values for the mixing-in OA-coated samples fluctuated. Generally, the solvent-aided coating method yielded less time dependency of alpha and higher WR persistence.